Uniden Camera Accessories UDRC13 User Manual

UDRC13  
ACCESSORY CAMERA  
Owner’s Manual  
Compatible with  
UDR444 Wireless  
Video Surveillance System  
If any items are missing or damaged, contact our Customer Care Line  
immediately. Never use damaged products!  
CUSTOMER CARE  
At Uniden®, we care about you!  
If you need assistance, please do NOT return this  
product to your place of purchase. Our customer  
care specialists are available to serve you.  
Quickly find answers to your questions by:  
Reading your owner’s manual, included with this  
product.  
Visiting our customer support website at www.  
uniden.com.  
Calling our customer care specialists at 1-817-  
858-2900 or 1-800-658-8068.  
Uniden surveillance products are not  
manufactured and/or sold with the intent to  
be used for illegal purposes. Uniden expects  
customers’ use of these products to be in  
compliance with all local, state, and federal law.  
For further information on video surveillance and  
audio recording legal requirements, please consult  
your local, state, and federal law.  
© 2013. All rights allowed by law are hereby  
reserved.  
 
parental supervision. Always be sure that both the  
transmitter and receiver are working properly, and  
are within range of each other.  
x
STRANGULATION HAZARD. Keep the adapter cords out  
of the reach of children.  
x
WARNING: KEEP OUT OF THE REACH OF CHILDREN.  
This product is not a toy and is not intended for use by any  
children under the age of 13. If you are between the ages  
of 13 and 18, review these terms, conditions and safety  
warnings with your parents or guardian to make sure that  
you and your parent or guardian understand these terms,  
conditions, and safety warnings.  
x
Allow for proper ventilation when units are in use. Do  
not cover the camera or receiver with any object such as  
a blanket. Do not place it in a drawer or in any location  
which would muffle the sound or interfere with the normal  
flow of air.  
SAVE THESE INSTRUCTIONS!  
FOR BEST RESULTS  
To avoid damage to your equipment, follow these  
simple precautions:  
x
Do not drop, puncture or disassemble any part of the  
equipment. There are no user-serviceable parts inside.  
x
Do not expose the equipment to high temperatures,  
and avoid leaving the equipment in direct sunlight for  
more than a few minutes. Heat can damage the case or  
electrical parts.  
x
x
x
Do not place heavy items on top of the equipment or  
expose the equipment to heavy pressure.  
Remove the power adapter during long periods between  
usages.  
Clean only with a dry cloth.  
Failure to follow the instructions in this operating  
manual will void the warranty. Uniden assumes  
no liability for damages to property or injury to  
persons caused by improper handling or failure to  
comply with these safety instructions.  
 
WHAT’S IN THE BOx  
Digital Wireless Camera (1)  
AC Adapter for Camera (1)  
Camera Stand with mount screws (1 set)  
Owner’s Manual (1)  
# If any items are missing or damaged, contact  
our Customer Care Line immediately!  
PARTS OF THE CAMERA  
Left side  
Front  
Right side  
6
7
1
10  
11  
14  
8
2
5
9
12  
13  
3
4
Item What it is  
1
Camera Antenna: Sends & receives signals  
to or from the monitor.  
2
3
PaIr: Pairs the camera to the monitor.  
Clip: This fastener can attach the camera to  
shelves or ledges.  
4
5
6
Suction base: Attach to mount the camera  
on glass surfaces.  
Light sensor: Measures light intensity on the  
camera side.  
IR LEDs (Covered): Infrared LEDs provide  
viewing in no/low light conditions.  
7
8
Lens: Camera lens.  
Speaker: Produces the sound transmitted  
from the monitor.  
 
Item What it is  
9
Microphone: Receives sounds for the area  
near the camera, and transmits sound from  
the camera to the monitor.  
10  
11  
POWEr: Turns the camera ON or OFF.  
Charging LED:  
Red = Charging  
Green = Fully charged  
Off = Camera and power adapter are  
disconnected or power adapter is  
disconnected from power source.  
12  
Power LED:  
Green = Camera is turned on.  
Green (Blinking) = Battery is low.  
13  
14  
DC 5V Power: Connects the DC 5V power  
adaptor to the camera.  
Reset the camera. Use a blunt object like an  
unbent paper clip to press rEsEt and reset  
the camera. The camera turns off. Press  
POWEr to turn it back on again.  
PAIR CAMERA TO MONITOR  
Refer to the UDR444 Wireless Video Surveillance  
System Owner’s Manual for pairing and other  
operation instructions.  
MOUNT THE CAMERA  
WALL MOUNT  
The UDRC13 clip has two slots that fit over screws  
to mount the unit on the wall.  
1. Mark the position of the screw holes on the  
wall.  
2. Drill holes and insert the anchors and screws  
provided.  
Be sure to leave room for the stand to fit over  
the screw heads.  
3. Place the stand over the installed screws and  
push it downwards, locking it into place.  
WALL  
 
4. Adjust the camera as needed.  
Suction Mount  
1. Insert the suction base into the base clip as  
shown:  
2. Firmly press the camera with the suction base  
attached onto glass or metallic surfaces.  
3. Adjust the camera as needed.  
Clip-Mount  
Clip the UDRC13 on ledges and shelves.  
1. Press the mounting clip as shown.  
2. Place the unit over the mounting surface and  
release.  
3. Adjust the camera as needed.  
Connect Power  
1. Insert the AC adapter power plug into the  
camera’s DC adaptor input jack.  
2. Plug the other end into a 120 volt AC (standard  
indoor) power outlet or surge protector.  
3. Press POWER and make sure the green power  
LED turns on. If it doesn’t, try reconnecting the  
AC adapter, making sure the power outlet isn’t  
controlled by a wall switch.  
 
PRODUCT SPECIFICATION  
GENERAL  
Operating frequency  
range  
2.400 ~ 2.4835GHz  
TX power  
15dBm (typical)  
FHSS  
Spread spectrum  
Modulation type  
Data Rate  
GFSK  
2 Mbps  
Communication range  
500 ft Line of Sight  
CAMERA  
Image Sensor Type - 1/6.5” CMOS Sensor  
Effective Pixel  
Image Processing  
Lens  
640 x 480  
MJPEG  
3.0mm / F2.8  
Auto  
Exposure  
White Balance  
Auto  
Power Requirement  
Power Consumption  
5.0VDC +/–5%  
150mA Max (IR OFF)  
730mA Max (IR ON)  
440mA Max (Charging)  
Operating  
Temperature Range  
14°F ~ 104°F ( –10°C ~ 40°C )  
Operating Humidity  
Range  
Within 80% RH  
RoHS Compliance  
Housing Material  
Yes  
Plastic  
RECyCling And diSpOSAl infORMATiOn  
x
Do not dispose of electronic devices or any of their  
components (especially batteries and LCD displays) in  
your municipal trash collection.  
 
x
x
Consult your local waste management authority or a  
recycling organization like Earth911.com to find an  
electronics recycling facility in your area.  
If you are unable to locate proper recycling facilities  
in your area, please return this product to Uniden for  
recycling.  
fCC COMpliAnCE infORMATiOn  
pART 15 COMpliAnCE STATEMEnT  
This device complies with Part 15 of the FCC  
Rules. Operation is subjected to the following two  
conditions: (1) this device may not cause harmful  
interference, and (2) this device must accept any  
interference received, including interference that  
may cause undesired operation.  
This equipment has been tested and found to  
comply with limits for a Class B digital device,  
pursuant to Part 15 of the FCC rules and ETSI  
(EN) 300328. These limits are designed to provide  
reasonable protection against harmful interference  
in residential installations. This equipment  
generates, uses, and can radiate radio frequency  
energy, and if not installed and used in accordance  
with the instructions, may cause harmful  
interference to radio communications.  
However, there is no guarantee that interference  
will not occur in a particular installation. If this  
equipment does cause interference to radio or  
television equipment reception, which can be  
determined by turning the equipment off and  
on, the user is encouraged to try to correct the  
interference by one or more of the following  
measures:  
x
x
x
Reorient or relocate the receiving antenna.  
Move the equipment away from the monitor.  
Plug the equipment into an outlet on a circuit different  
from that to which the monitor is connected.  
x
Consult the dealer or an experienced radio/television  
technician for additional suggestions.  
 
# CAUTION! Any changes or modifications to  
this equipment not expressly approved by the  
party responsible for compliance could void  
your authority to operate the equipment.  
Rf ExpOSURE infORMATiOn  
The antenna used for this transmitter must be  
installed to provide a separation distance of at  
least 20 cm (7.9”) from all persons and must not  
be collocated or operating in conjunction with any  
other antenna or transmitter.  
iC COMpliAnCE infORMATiOn  
RAdiO EqUipMEnT nOTiCE  
The term “IC:” before the radio certification number  
only signifies that Industry Canada technical  
specifications were met. Operation is subject to the  
following two conditions: (1) this device may not  
cause interference, and (2) this device must accept  
any interference, including interference that may  
cause undesired operation of the device. “Privacy  
of communications may not be ensured when  
using this device”.  
CE COMpliAnCE infORMATiOn  
Products with CE Marking comply with EMC  
Directive (2004/108/EC); Low Voltage Directive  
(73/23/EEC); R&TTE(1999/5/EC) issued by  
the Commission of the European Community.  
Compliance with these directives implies  
conformity to the following European Norms:  
x
x
x
EMC: EN 301 489  
LVD: EN 60950  
Radio: EN 300 328  
OnE-yEAR liMiTEd WARRAnTy  
# Important: Evidence of original purchase is  
required for warranty service.  
WARRANTOR: UNIDEN AMERICA  
CORPORATION (“Uniden”) ELEMENTS OF  
WARRANTY: Uniden warrants, for one year, to the  
 
original retail owner, this Uniden Product to be free  
from defects in materials & craftsmanship with only  
the limitations or exclusions set out below.  
WARRANTY DURATION: This warranty to the  
original user shall terminate & be of no further  
effect 12 months after the date of original retail  
sale. The warranty is invalid if the Product is (A)  
damaged or not maintained as reasonable or  
necessary, (B) modified, altered, or used as part  
of any conversion kits, subassemblies, or any  
configurations not sold by Uniden, (C) improperly  
installed, (D) serviced or repaired by someone  
other than an authorized Uniden service center for  
a defect or malfunction covered by this warranty,  
(E) used in any conjunction with equipment or  
parts or as part of any system not manufactured by  
Uniden, or (F) installed or programmed by anyone  
other than as detailed by the owner’s manual for  
this product.  
STATEMENT OF REMEDY: In the event that the  
product does not conform to this warranty at any  
time while this warranty is in effect, warrantor  
will either, at its option, repair or replace the  
defective unit & return it to you without charge  
for parts, service, or any other cost (except  
shipping & handling) incurred by warrantor  
or its representatives in connection with the  
performance of this warranty. Warrantor, at  
its option, may replace the unit with a new or  
refurbished unit.  
THE LIMITED WARRANTY SET FORTH  
ABOVE IS THE SOLE & ENTIRE WARRANTY  
PERTAINING TO THE PRODUCT & IS IN LIEU  
OF & EXCLUDES ALL OTHER WARRANTIES  
OF ANY NATURE WHATSOEVER, WHETHER  
EXPRESS, IMPLIED OR ARISING BY  
OPERATION OF LAW, INCLUDING, BUT NOT  
LIMITED TO ANY IMPLIED WARRANTIES  
OF MERCHANTABILITY OR FITNESS FOR A  
PARTICULAR PURPOSE. THIS WARRANTY  
DOES NOT COVER OR PROVIDE FOR  
 
THE REIMBURSEMENT OR PAYMENT OF  
INCIDENTAL OR CONSEQUENTIAL DAMAGES.  
Some states do not allow this exclusion or  
limitation of incidental or consequential damages  
so the above limitation or exclusion may not apply  
to you.  
LEGAL REMEDIES: This warranty gives you  
specific legal rights, & you may also have other  
rights which vary from state to state. This warranty  
is void outside the United States of America &  
Canada.  
PROCEDURE FOR OBTAINING PERFORMANCE  
OF WARRANTY: If, after following the instructions  
in the owner’s manual you are certain that the  
Product is defective, pack the Product carefully  
(preferably in its original packaging). Disconnect  
the battery from the Product & separately secure  
the battery in its own separate packaging within  
the shipping carton. The Product should include all  
parts & accessories originally packaged with the  
Product. Include evidence of original purchase &  
a note describing the defect that has caused you  
to return it. The Product should be shipped freight  
prepaid, by traceable means, to warrantor at:  
Uniden America Service  
743 Henrietta Creek Rd.  
Roanoke, TX 76262  
(800) 297-1023, 8 a.m. to 5 p.m., Central, Monday  
through Friday  
 

Telex Headphones HD 3A User Manual
Texas Instruments Network Card UCC38500EVM User Manual
Tiffen Water System Smoque User Manual
Toshiba DVD Player SD 4100 User Manual
Toshiba Laptop A305 S6916 User Manual
Toshiba TV DVD Combo 26HLV66 User Manual
Tyco Network Card KT MOD OUT16 User Manual
Uniden Telephone FP104 User Manual
Uniden Telephone TRU 8885 SERIES User Manual
VeriFone Credit Card Machine QX1000 User Manual